
This is a little belated, but I bottled my beer a week and a half ago (2/19). It is sitting comfortably, again, in my hallway closet. This time it is divided into 41 bottles, instead of the 5 gal carboy. I'm going to give it about 4 weeks before I open the first bottle. I'm not sure which one will come first, 4 weeks or St. Patrick's day, but that is the time frame I'm looking at.
The last, and first, time I bottled beer I had the help of my roommate. "Help" is very understated because an extra pair of hands was greatly appreciated and needed. Performing this part of the brewing process is best done with a friend or drinking buddy. So, here is the basic process of bottling. Done by yours truly:

- Open the ancient box of empty beer bottles and remember the beer you drank 4 years earlier (weird to say the least)
- Thoroughly wash and scrub each bottle with a bottle brush - this looks like a giant pipe cleaner with a twisted metal handle
- Wash a bin or any large container and fill with a water/sanitizer solution. In this case, I used some plastic drawers that I wasn't using and used StarSan sanitizer again. Let bottles soak for recommended amount of time (this particular sanitizer has to stay in contact with the surface for at least 1-2 minutes). Soak and sanitized the bottle caps, bottling bucket, siphon and any other tool that will be used during bottling. - Drain and air dry the bottles and equipment.
- Prepare priming sugar - this is usually provided with the ingredients to make the beer. Dissolve sugar in boiling water and allow to cool before adding to sanitized/dry bottling bucket (or follow directions for specific sugar). The residual yeast left in the beer will consume the sugar added. Alcohol and CO2 is given of by the yeast. The CO2 released at this point provides the carbonization of the beer. - Remove fermenter (the glass carboy) from its hibernation location and place on your counter or any space high off of the ground. Place the bottling bucket on the ground under the carboy, spout closed.
- Fill the sanitized siphon tube with water. Place racking cane in beer/carboy (at least 2-3 inches from bottom ad away from the settlement) and the other end in the bottling bucket. Release the clamp and the water should pull the beer out of the carboy and begin siphoning it into the bottling bucket. Siphon all the beer out without pulling any settlement from the bottom.

- Place bottling bucket on counter and attach siphon tube to the spout, with bottling attachment on the other end of the tube. Begin filling the empty beer bottles to about 3/4"
from top. Try not to aerate the beer at this point, add beer slowly without gushing.
- Cap all filled beer bottles with sanitized bottle caps.
- Store in a cool, dark place to continue the fermentation process.

Care taken during this part of the brewing process is very important to prevent contamination of the beer. Sanitize all of your equipment thoroughly. You've come this far, don't be careless and add bacteria that shouldn't be there. Cross your fingers and hope for delicious and refreshing beer!